For cleaning solutions
Stinkers can take your efforts to the next level by not only cleaning  but also giving you a fresh crisp surface that resists odors.

Mix Stinkers directly into your cleaning solution at a ratio of 4 to
6 oz. of Stinkers per gal. of cleaning solution. Proceed to clean using your normal cleaning process.

For Immediate and Permanent removal of odors caused by pets, skunk, mold, dead animal and more...

Stinkers, the newest technology in odor removal, integrates the science of (Absorption, Pairing, Modification, and Encapsulation) to safely and permanently eliminate odors without leaving objectionable fragrance or sticky residue behind.

Use Stinkers for:

• Urine, feces, vomit, skunk etc.
• Pet bed, upholstery, & mattress odors.
• Deodorizing shampoo for animal care.
• General malodor of carpet, pet runs etc.
• Freshen up while cleaning.
• Putrefaction (decomposing flesh and organic matter)

For strong embed odors
(Urine, vomit, feces):
Flood the contaminated area sufficiently to soak the surface and liberally penetrate into all sub surfaces where the odor may have migrated. Allow a 10 minute dwell time then vacuum away excess solution from the area. If possible allow area to dry before cleaning. Odors should be gone within minutes. If odor remains it is because Stinkers has not been in contact with all the contamination.

Important Note:
If cleaning must be performed at the time of treatment, apply the Stinkers to the dry carpet prior to any cleaning and re-moisten surface fibers with Stinkers after the cleaning.

For surface odors:
Spray the contaminated area and allow the area to dry.

Pet bed, upholstery, & mattress odors.
Stinkers is an excellent treatment to eliminate odors from pet beds, upholstery or mattress odors. Using the trigger sprayer, mist the surface of the fabric and brush gently to improve penetration. Allow to dry before using.

General malodor of carpet, pet runs etc. 
To eliminate pet body odors from carpets, automobiles, pet runs, etc. Use the trigger sprayer to evenly apply the solution. Allow area to dry before using.